Demystifying how the wheel dehumidifier is maintained and maintained 1. The inlet and outlet of the recirculating dehumidifier should not be obstructed, and the filter net should be cleaned.
2. The wheel dehumidifier should be placed in the center of the room.
3. The condenser should be cleaned from time to time and kept clean.
4. If the humidity in the air is less than 30%, it is too dry and uncomfortable, so the reliable humidity controller should be controlled to maintain the range of 50% to 60%. When using, the doors and windows are closed as much as possible to achieve dehumidification in the room. The body should be placed flat, not tilted or slanted to avoid machine malfunction or abnormal noise.
5. When the ambient temperature is lower than 15 °C, the water droplets attached to the surface of the evaporator will freeze and the effect of the dehumidifier will be weakened. If the ambient temperature exceeds 40 °C, the pressure in the system will increase and the compressor will be overloaded. The protector should cut off the line or the compressor motor will be damaged. Therefore, the dehumidifier is suitable for use in a temperature range of 15 ° C to 40 ° C.
6. If the water storage capacity in the dehumidifier is too full, in order to avoid overflowing the dirty ground, you must unplug the power cord before dumping the body, and then pour off the water in the bucket.
7. The wheel dehumidifier regularly cleans the filter gas network (about once every two weeks) to maintain the dehumidification, dust removal efficiency and life of the machine. Clean the filter gas net to wash with water below 40 °C; use detergent to clean better, wash off the dust, rinse with water, dry it and put it back into the body. When cleaning the body, wipe it gently with a damp cloth; avoid direct splashing of water to avoid damage to electrical insulation. There are adhesives on the surface of the body, which can be washed with soapy water to avoid spraying with gasoline, petroleum spirit, solvent or spray insecticide to avoid peeling or discoloration. Do not use thin rods or wires to pry the inside of the machine to avoid malfunction or danger.
8. After the runner dehumidifier has been moved for four to six hours, it will be turned on and used again. Because the compressor line in the dehumidifier contains cold coal, after moving, the cold coal must return after four to six hours. In situ.
9. When the power is off or not used for a long time, when you are traveling, please unplug the power cord to maintain the life of the machine.
2. The wheel dehumidifier should be placed in the center of the room.
3. The condenser should be cleaned from time to time and kept clean.
4. If the humidity in the air is less than 30%, it is too dry and uncomfortable, so the reliable humidity controller should be controlled to maintain the range of 50% to 60%. When using, the doors and windows are closed as much as possible to achieve dehumidification in the room. The body should be placed flat, not tilted or slanted to avoid machine malfunction or abnormal noise.
5. When the ambient temperature is lower than 15 °C, the water droplets attached to the surface of the evaporator will freeze and the effect of the dehumidifier will be weakened. If the ambient temperature exceeds 40 °C, the pressure in the system will increase and the compressor will be overloaded. The protector should cut off the line or the compressor motor will be damaged. Therefore, the dehumidifier is suitable for use in a temperature range of 15 ° C to 40 ° C.
6. If the water storage capacity in the dehumidifier is too full, in order to avoid overflowing the dirty ground, you must unplug the power cord before dumping the body, and then pour off the water in the bucket.
7. The wheel dehumidifier regularly cleans the filter gas network (about once every two weeks) to maintain the dehumidification, dust removal efficiency and life of the machine. Clean the filter gas net to wash with water below 40 °C; use detergent to clean better, wash off the dust, rinse with water, dry it and put it back into the body. When cleaning the body, wipe it gently with a damp cloth; avoid direct splashing of water to avoid damage to electrical insulation. There are adhesives on the surface of the body, which can be washed with soapy water to avoid spraying with gasoline, petroleum spirit, solvent or spray insecticide to avoid peeling or discoloration. Do not use thin rods or wires to pry the inside of the machine to avoid malfunction or danger.
8. After the runner dehumidifier has been moved for four to six hours, it will be turned on and used again. Because the compressor line in the dehumidifier contains cold coal, after moving, the cold coal must return after four to six hours. In situ.
9. When the power is off or not used for a long time, when you are traveling, please unplug the power cord to maintain the life of the machine.
China Natural Plant Herbal Extract,Lotus Leaf Extract,Curcuma Extract,Grape Seed Extract, we offered that you can trust. Welcome to do business with us.
Our healthway supply Medical Intermediate Herbal Extracts Natural Plant Herbal Extract Super Food Ingredients Fruit Powder Fruit Juice Powder Freeze-dried Powder Vegetable Powder Food Additives Cosmestic Ingredienrs
Icariin NMN powder Cissus Irish sea moss Quercetin Barley grasss, We had passed FDA certificate and ISO 9001 .
Natural Plant Herbal Extract,Lotus Leaf Extract,Curcuma Extract,Grape Seed Extract
Xi'an Healthway Biotech Co.,Ltd , https://www.xahealthway.com