1. Water immersions should be selected where water is shallow, bottom is hard, slopes on both banks are gentle, and water flow is stable. 2. If the flow velocity at the wading site is too rapid, it should pass in a diagonal direction along the direction of the water flow. If the water surface is wide, the sign should be set to indicate the direction of travel, and trees, houses, power poles, etc., can also be selected as targets on the opposite bank. 3, when the wading depth exceeds the axle, should do all kinds of waterproof work. If you remove the fan belt, use a soft leather tube over the exhaust pipe and bend it upwards, wrap it with a waterproof cloth, and raise the battery to a certain position. If the water depth exceeds the maximum wading depth of the agricultural vehicle, you should not risk wading. 4, before wading, if the tire and brake hub temperature is higher, should be slightly rest, wait until it is properly cooled before launching. 5, when wading, should be smoothly into the water from the shore to splash water splash. In order to ensure that the engine has sufficient power, it should be passed at a uniform speed, avoiding stoppages, shifts, and jerk directions. Eyes must look at the target on the other side of the bank. Don't look at the water to avoid disturbing your vision and losing your direction. 6, wading in water, if the vehicle skids idling, you should immediately stop, do not barely advance and retreat, but can not shout throttle, and to ensure that the engine does not turn off. Put stones, wood, etc. around the tires to strengthen the geological hardness and use other vehicles to assist in towing. If the bottom of the water is loose and loose sand, the engine should be turned off so as not to become deeper and deeper under the jitter of the engine. Human or other vehicles should be organized to assist in towing. 7. When passing through the flooded sandstone or mud road sections, it should be on the water side of the road and travel in a low gear. To prevent the erosion of the water stream on the water side, a large amount of earth and stone is lost, pits are formed, gaps are formed, and collapse occurs after being pressed to cause accidents. 8. When wading through multiple vehicles, do not launch into the water at the same time. When the vehicle arrives at the other side of the car, the vehicle will be driven into the water again to prevent the vehicle from being parked for any reason, forcing the vehicle to be stopped in the water.
Feeding Supplies ,Glass Baby Feeding Bottle,Borosilicate Glass Baby Bottle
Molded Vial Co., Ltd. , http://www.nsmedicalcontainer.com